Been trying to get on top of the body work in preparation for paint. Not a lot of fun work 😉 Reassembled and aligned the hood so I could install the hood pins. All old factory latch components have been removed. Using the headlight mounting points, I welded some pipe to a piece of flat iron with two holes for the mounts, then welded a nut to the top that the adjustable pin threads into. Since the retaining nuts on …

Read more »

Dragon Revival

As I have time, I have been ticking away here and there on this project. Slowwwwly. Pan on, motor mounts on, and crossmember installed. In preparation for the engine, the engine bay needed some paint. The dash. And the rollbar. For now the rest of the cage is removed. The interior is primed and ready for white paint.

Dragon Revival

Oh I’m not really sure where I last left off here. I have been doing stuff slowly as I have time on the Dragon, without much rhyme or reason. My main concern right now is getting the car ready for paint, so there is a lot of prep work to do. Conversion parts are here for the motor, so I will start bolting that stuff together soon. Front panels off for paint prep. I also started getting rid of a …

Read more »

Rod Bearings LSX

Thought I had a few minutes today to torque the new rod bearings into place on the LSX motor. Never fails when you are doing something important that you get bombarded with phone calls and visits 🙂 I think I retorqued these about 3x each as you don’t want to guess which bolt is at which stage after you forget, lol. The LSX motor takes the torque in two steps, 15ft/lbs, then a 75 degree rotation. Ready to go. My …

Read more »