This 964 came back in after it’s new battery due to some front end noise that the owner noticed after he had new tires installed. Likely the noise has been there since he just bought the car, and he just noticed it after the tires were installed. We did swap wheels to rule out anything with a possible bad tire. While I had it in there air inspecting for any signs of rubbing, I noticed we had some inner tire …

Read more »

Finished up the C4 today by installing new CV axle boots on both rear axles. A quick rebuild of the joints and some fresh grease, and this puppy is ready for the DE this weekend. Hanging the axles, ready to come out. Outer nut takes over 350ft/lbs of torque. And the assembly on my makeshift cardboard bench. And new axle boots installed on the first axle. Repeat on the 2nd and we were done.

964 Finished

Got the parts in yesterday and was able to get the track car wrapped up and back on the road. After getting the new thermostat in place, we finally got hot oil up to the coolers and the temp gauge was running where it should. I disconnected the front sensor to default the fan to high as most of this car’s operating time will be one track or sitting on grid. This will help with cooling down after coming in …

Read more »

After running the car at MAM last weekend, we started getting hot at the end of our last session on Saturday. We loaded up and headed home as planned, and today I picked the car back up to start going through it for our event at Road America in a few weeks. Up and ready to go. First things first was to figure out why our cooling fans were not coming on for the oil cooler. Then tackle getting some …

Read more »