Miata head done

If you have been following this build we showed the sorry state this head was in before.   Now decked with new seals and all of the valves seated the head is ready to go back together.

Cam seals in the front, new O-ring for the cam angle sensor on the back of the left bank (right as seen from front.)

Seals in, cams now torqued, water neck sealed, ready to go!

One tip: While the cam sensor can be re-installed while in the car, do it now.  It is tons easier here.

 

More from the Blog

Leave a Reply

Your email address will not be published. Required fields are marked *